![]() The red wire is connected to the same terminal block that contains the brown wire going to the lampholder, the black wire is connected to the same terminal block that contains the blue wire going to the lampholder and the earth wire is connected to the earth terminal. The cable going to the ceiling rose is connected as follows (fig 4). The following diagram shows an example of two lights that share the same supply cable but each have their own switch. When using a ceiling rose on a circuit that utilises the in line switching method, again the wiring is quite easy, the difficult part is working at height and above your head. ![]() If you are using metal light switches (fig 3) make sure you connect the earth wire to the earth terminal on the switch and fit an earth link wire from the switch to the earth terminal in the back box. The (L2) terminal is unused.Ī metal light switch must be earthed as seen below. Each two wire cable connects to a screw in the switch box. The wiring is done by running two wires to each light location. If you are using a plastic switch the earth wires will need to be connected to the terminal in the terminal box (as shown above) because there are no earth terminals on plastic switches.Ī two way light switch can also be used in in place of a one way light switch, in this instance the red wire from the feed cable is connected to the common (C) terminal and the red wire going to the light is connected to the (L1) terminal. Wiring multiple lights to one switch is simple and easy. The red wire from the feed cable is connected to the top terminal, the red wire going to the light is connected to the bottom terminal, the black wires from both cables are connected together in a plastic terminal block and the earth wires are connected to the earth terminal. The cable going to the light switch is connected as follows (fig 2). The easiest way to connect multiple lights to one switch is to daisy-chain the lights, which means to connect them together and attach just one of the. Line diagram of a one way lighting circuit using in line method (fig 1).Ī one way light switch is quite easy to wire up. You can do this light switch wiring in one of two ways. Check all wires for current with your voltage tester. One way lighting circuit using in-line switching If there is already a switch with one light installed, return to the switch and remove the cover.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |